Doxygen allows you to put formulas in the output (this works only for the HTML and output, not for the RTF nor for the man page output). To be able to include formulas (as images) in the HTML documentation, you will also need to have the following tools installed
latex:
the compiler, needed to parse the formulas. To test I have used the teTeX 1.0 distribution. dvips:
a tool to convert DVI files to PostScript files I have used version 5.92b from Radical Eye software for testing. gs:
the GhostScript interpreter for converting PostScript files to bitmaps. I have used Aladdin GhostScript 8.0 for testing. For the HTML output there is also an alternative solution using MathJax which does not require the above tools. If you enable USE_MATHJAX in the configuration then the latex formulas will be copied to the HTML "as is" and a client side javascript will parse them and turn them into (interactive) images.
There are three ways to include formulas in the documentation.
Using in-text formulas that appear in the running text. These formulas should be put between a pair of \f$ commands, so
The distance between \f$(x_1,y_1)\f$ and \f$(x_2,y_2)\f$ is \f$\sqrt{(x_2-x_1)^2+(y_2-y_1)^2}\f$.
results in:
The distance between and is .
\f[ |I_2|=\left| \int_{0}^T \psi(t) \left\{ u(a,t)- \int_{\gamma(t)}^a \frac{d\theta}{k(\theta,t)} \int_{a}^\theta c(\xi)u_t(\xi,t)\,d\xi \right\} dt \right| \f]results in:
environment
is the name of the environment, the corresponding end command is \f}. Here is an example for an equation array \f{eqnarray*}{ g &=& \frac{Gm_2}{r^2} \\ &=& \frac{(6.673 \times 10^{-11}\,\mbox{m}^3\,\mbox{kg}^{-1}\, \mbox{s}^{-2})(5.9736 \times 10^{24}\,\mbox{kg})}{(6371.01\,\mbox{km})^2} \\ &=& 9.82066032\,\mbox{m/s}^2 \f}which results in:
For the first two commands one should make sure formulas contain valid commands in 's math-mode. For the third command the section should contain valid command for the specific environment.
formula.repository
that is written to the html directory to get rid of an incorrect formula.